Buy discount CMT 800.501.11 8-Piece Dovetail & Straight 1/2-Inch Shank Router Bit Set Good sharp carbideBy Michael H. YoungThe sharp carbide cuts well, and works nicely with Incra jigs. There is, however, a surprising amount of chatter on half-blind pin cuts that seems to not respond to changes in feed rate or cutter speed. The resulting vibration is severe enough to upset the depth setting on the plunge router, ruining the joint and the piece. The top of the dovetail bits are single sharp points at each flute, rather than a flat scraping edge. However, I haven't identified the cause, and don't necessarily suspect the bit or the design of the cutter. In other use, the bits are sharp, and yield very fine, clean shavings with very little dust.1 of 2 people found the following review helpful. » More Information about CMT 800.501.11 8-Piece Dovetail & Straight 1/2-Inch Shank Router Bit Set.Sunday, June 26, 2011
CMT 800.501.11
Buy discount CMT 800.501.11 8-Piece Dovetail & Straight 1/2-Inch Shank Router Bit Set Good sharp carbideBy Michael H. YoungThe sharp carbide cuts well, and works nicely with Incra jigs. There is, however, a surprising amount of chatter on half-blind pin cuts that seems to not respond to changes in feed rate or cutter speed. The resulting vibration is severe enough to upset the depth setting on the plunge router, ruining the joint and the piece. The top of the dovetail bits are single sharp points at each flute, rather than a flat scraping edge. However, I haven't identified the cause, and don't necessarily suspect the bit or the design of the cutter. In other use, the bits are sharp, and yield very fine, clean shavings with very little dust.1 of 2 people found the following review helpful. » More Information about CMT 800.501.11 8-Piece Dovetail & Straight 1/2-Inch Shank Router Bit Set.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment